1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 187Get this manual
TILT CYLINDER Put new O-ring onto fitting and screw fitting onto band, being sure pilot on fitting mates with hole in cylinderSee Figure 9-22If piston assembly has been disassembled, insert piston rod into end head assembly being careful not to damage sealsApply OMC Nut Lock to piston rodWith small holes in piston faCing up, tighten piston securely onto rod Lubricate piston assembly with OMC Sea Lube Power TrimTilt FluidInsert assembly into cylinderTighten end head assembly onto cylinder using spanner wrenchLubricate cylinder pivot pin with OMC Sea Lube Anti-Corrosion Lube and install cylinder assembly with upper oil line fitting on starboard sideSee Figure 9- 22TRIM CYLINDER Insert piston and rod assembly into end capInsert piston into trim cylinder so that both piston and cylinder sleeve are butted against end capSee Figure 9-23Insert unit into cylinder cavityTighten end cap securely with spanner wrenchIf band has been removed, slide onto cylinder 1End cap, trim piston and cylinder sleeve 2Trim cylinder cavity