1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 184Get this manual
DISASSEMBLY NOTE Complete disassembly is given here, but remove only parts necessary for inspection or replacementDrain system by removing reservoir plug and draining fluid into panVALVES AND PISTONS Manual release valve is removed by removing snap ring with number snap ring pliersValve is then removed from cavitySee Figure 9-14
1Spring clip 2Tilt cylinder pin
Figure 9-12Removing Tilt Cylinder Pin Mark thrust rod location and remove rodRemove three screws, port and starboard, holding power trim assembly to stern bracketsRemove both stern bracketsRemove spring clip from tilt cylinder pinSupport weight of power trim unit while removing tilt cylinder pinSee Figure 9-12Testing and repair of the unit will be easier if pair of stands is usedThey can be fabricated from 14" or 516" aluminum stockSee Figures 9-7 and 9-13