1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 162Get this manual
peller shaft will turn freely when in neutral)Note amount of free play in shift lever and position lever in center of this travelPosition shift control cable on engine so that cable is in lower notch in anchor blockInstall cable retainer but do not tightenTurn the trunnion adjustment nut until hole in casing guide is in line with pin on shift lever(Flat on eaSing must face lever Attach casing guide to shift lever pin using washer and locknut suppliedSee Figure 8-1210Slip rubber grommet onto the two control cables and press grommet into groove in lower motor coverTighten cable clamp screws securelySee Figure 8-1211Connect battery cables and check operation of control 6Remove screw and cover exposing cam detent spring and ballSee Figure 8-137Remove countersunk screw, flat washer, shift lever and bushingSee Figure 8-14
ELECTRICAL COMPONENT REPLACEMENT
neeessary to replace electrical components or clean and inspect mechanical parts, it will be necessary to remove arm rest, control lever and upper housing1Disconnect battery cables and detach control from boatSee CONTROL SERVICE2Remove three screws, washers and arm rest3Remove Allen screw and control leverFigure 8-9See