1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 161Get this manual
3Determine which of two cables is for throttle controlLubricate end of cable with OMC Sea- Lube Anti-Corrosion LubeSlide one casing guide over end of throttle cable and control wireBe sure the "0" ring is in place in casing guide4Secure the control wire in the casing guideThe control wire is held securely in place by two clamp screws, but the wire must be kinked to insure positive locationThis is easily done by first turning clamp screw (using 332" Allen wrench) until it just touches the wireNext advance this clamp screw one turn onlyThis will kink the wire sufficiently to locate it in the casing guideFinally, install the anchor screw and tighten securelySee Figure 8-10NOTE is possible to completely shear off the wire, so be careful to advance the clamp screw to the point of contact only and then make just one complete turn to kink the wire without shearing itIt
7Grasp throttle cable casing guide and trunnion nutPull firmly on caSing guide to remove backlash from cable and remote control
Unless baCklash is removed before connecting and adjusting throttle cable, engine may not return to consistent idle speed8Position the throttle cable in upper notch in anchor blockSee Figure 8-12Adjust the trunnion adjustment nut on cable until hole in caSing guide slips over throttle lever pinAttach casing guide to throttle lever with washer and locknut