1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 159Get this manual
and loosen front control wire clamp screw(s)Thru access hole in back of control box, loosen rear clamp screw(s)See Figure 8-52Lift control cable trunnion(s) out of control box and disengage wire(s) from casing guide(s)See Figure 8-5 3Remove locknut and washer and disconnect throttle control cable from throttle leverSee Figure 8-64Remove locknut, washer and shift control cable from shift leverSee Figure 8-65Loosen anchor block clamp screws and swing clamps asideRemove the rubber grommet from front of lower motor cover, and disengage from cablesSee Figure 8-76Remove cable clamps attaching cable(s) to boat
1Throttle control clevis
2Casing guide 3Nylon trunnion caps 4Front control wire clamp screws 5Rear control wire clamp screws
1Cable clamps
2Grommet
Figure 8-7
Figure 8-5Casing Guides fustalled
INSTALLATION IN CONTROL BOX
1Place control lever in NEUTRAL position and