1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 153Get this manual
Connect the ohmmeter (LO ohms scale) between the yellow and yellowgray leadsA reading of .25 ohms .1 indicates the windings are good, and an infinite reading indicates the windings are openSee Figure 7-38 REPLACEMENT OF ALTERNATOR
If windings are found to have failed, the stator as-
sembly must be replaced
Proceed as follows:
aRemove flywheel, using flywheel puller (Special Tool #378103)See Section 5bDisconnect stator and charge coil leads at terminal board and Power PacksRemove four screws and lift stator from power headSee Figure 7-39cPlace new stator in position and attach with four screws dipped in OMC Screw LockTighten to torque of 120 to 144 inch-poundsReconnect stator and charge coil leads