1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 151Get this manual
eCheck starter motor with no load testWith 12 volts applied to the motor terminals, maximum current draw should be 90 amperes and minimum speed should be 5500 rpmSee Figure 7-5 If visual inspection of the electrical system shows
INSTALLATION OF STARTER
aPlace starter in position against crankcase, and secure with three screwsSee Figure 7-6Attach clamp to upper mounting screw before tightening screwTorque to 14-16 ftlbsbReconnect starter motor leadcReinstall port electrical component bracketSecure with two nuts and one boltSee Figure 7-6
all components to be in good condition, an electrical inspection will be necessary to determine which component of the charging system is the cause of troubleSee Figure 7-35
AL TERNATOR YELLOW
Y ELL OW GRAY
RED PURPLE
TERMIN AL BL OCK RED
CHARGING SYSTEM (15 AMP)