1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 143Get this manual
REMOVAL OF STARTER Due to the construction of the starter motor, maintenance operations are generally limited to periodic checking for looseness of mountingUnless it is certain that the starter motor requires attention, do not remove it for overhaulA thorough check should be made of the battery, cables, starting solenoid, and switch as outlined in the Trouble Check Chart in Section 2Check the Prestolite starter motor by using the no load testWith 12 volts applied to the starter motor, maximum current should be 90 amperes and minimum speed should be 5500 rpmCheck Bosch starter no load testWith 12.0 to 12.4 volts applied, maximum current draw should be 25 amps, speed 6000 to 7000 rpmSee Figure 7-5Remove starter motor for test as follows: aDisconnect red lead from starter motorbRemove two nuts and one bolt from electrical bracket, move electrical component bracket as re-