1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 134Get this manual
fPosition frame and seal assembly in lower motor coverSee Figure 6-115 INSTALLATION OF GEARCASE
aPlace "0" ring on driveshaftCoat driveshaft splines with OMC Sea- LubeMoly LubeDo not coat top surface of shaft as lubricant here may prevent seating of driveshaft in crankshaftbApply OMC adhesive "M" to gearcase and exhaust housing surfacescCarefully install gearcase making sure water tube enters impeller housing cover and pump grommetSee Figure 6-41dDip gearcase attaching screws in OMC Gasket Sealing Compoundfustall and tighten to torque specified in Section 2ebstall trim tab and align with marks made at disassemblyIf not marked at disassembly, set trim tab adjustment from "1-12" to "2" on trim tabSee Figure 6-117