1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 132Get this manual
cInsert tilt tube bushings in swivel bracketLubricate tilt tube with OMC Sea-Lube Anti-Corrosion LubePlace washer on tilt tube and install port side tilt tube and stern bracketdPlace washer on starboard end of tilt tubeInstall starboard stern bracketAttach power trim and tilt manifold to port and starboard stern bracketsTorque screws to specifications in Section 2eThread tilt tube nut onto tilt tube and torque to 24-26 ftIbs then back off 18 to 14 turn after torquingSee Figure 6-108 1Steering arm 2Pivot shaft keepers 3Mount bracket
Figure 6-109Steering Arm Installed
Figure 6-108Torquing Tilt Tube Nut
fInstall thrust rod and spring
gIf removed, install bushing in swivel bracketInstall new upper and lower seals with lips faCing outhLubricate steering arm and pivot shaft assembly with OMC Sea-Lube Anti-Corrosion LubePlace upper thrust washer on shaft, and install shaft in swivel bracketSee Figure 6-109L Place lower thrust washer and pivot shaft keepers on pivot shaftInstall mount bracket in alignment with steering arm as shown in Figure' 6-110Apply OMC Gasket Sealing Compound to threads of nutTorque nut to specifications in Section 2(130 to 150 ftIbs