1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 103Get this manual
iAttach body from Universal Puller (OMC Special Tool #378103) to flywheel with screws and washers Tighten screwsThread lifting eye (OMC Special Tool #321537) into puller body until point on lifting eye engages taper in end of crankshaftTighten lifting eyeUsing hoist, lift power head straight up to avoid damaging drive shaft splinesSee Figure 6-17While power head is suspended from hoist, thread the four stud nuts onto the studs until flush with ends of studs to protect threadsjRemove gearcaseSee "Removal of Gearcase See page 6-5 1 Rear rubber mount screws
Figure 6-18Lower Motor Cover Frame and Seal Screws (Indicated by Broad Arrows)
1Lifting eye #321537 2Puller set #378103
Figure 6-17Removing Power Head Assembly