1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 62Get this manual
1Adapter 2Orange lead 3High tension lead (secondary) 4Ground probe 5Orangeblack lead Figure 4-38Leakage Test
1Timing pOinter 2Screw
Figure 4-39TDC Alignment mark on the flywheel are in agreement, the timing pOinter alignment is correctIf not, proceed to Step 5
TIMING POINTER ADJUSTMENT
Engine performance depends on the accuracy of ignition timing and carburetor synchronizationIf major power head components have been replaced, or timing pointer disturbed, the pointer should be rechecked against the TDC mark on the flywheelTo check and adjust, proceed as follows: 1Disconnect spark plug leads and remove spark plugs 2Temporarily set timing pointer mid-way in its adjusting slotSee Figure 4-39Install Piston Stop Assembly Tool (Special Tool #384887) in No.1 cylinder spark plug holeSee Figure 4-40Turn flywheel clockwise until piston contacts end of toolAdjust tool to 12 TDC and lock tool