1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 46Get this manual
Connect the high tension lead wires to the spark plugsMake sure that the spring Clips in the spark plug lead covers make firm contact with the spark plug terminalsSee Figure 4- 5 1Stator 2Sensor and timer assembly (sensor coils are potted)
Figure 4-4BStator Sensor and Timer 9Returning to the first pole (slot) of the sensor magnet, in an additional 30 of travel, it will pass sensor #5, developing positive pulse to turn on SC #5The capacitor's energy is discharged through the #5 ignition coil primary, through SCR #5 and back to the capacitor, inducing high voltage into the ignition coil secondary, firing across the spark plug gap of cylinder #5SCR #5 returns to its non- conducting state and the capacitor is recharged10Again the second pole (slot) of the sensor magnet travels 90 further where it will pass sensor #6, developing positive pulse to turn on SCR #6The capacitor's energy is discharged through the #6 ignition coil primary through SCR #6 and back to the capacitor, inducing high voltage into the ignition coil secondary, firing across the spark plug gap of cylinder #6SCR #6 returns to its non-conducting state and the capacitor is rechargedThis all takes place in one revolution of the engine, and then the sequence begins all over again for the next revolution