1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 34Get this manual
closed)Snap out throttle linkIf adjustment is correct with engine idling, RPM should not changeb Loosen carburetor choke rod fastener lock screwsPlace manual choke lever in choke "On" positionSee Figure 3-32Manually close the other two choke valves and tighten screws 1Upper carburetor lever adjustment screw 2Lower carburetor lever adjustment screw 3Cam follower 4Space between roller and cam 5Throttle cam 6Choke rod screws
1Center carburetor choke shaft and lever assembly 2Solenoid link 3Ground lead 4Attaching screws (2) 5Solenoid assembly 6Spring 7Plunger 8Clamp 9Link retainer 10Slot in plunger
Figure 3-33Correct Choke Solenoid Installation and Adjustment
Figure32Synchronizing Throttle and Choke Valves
THROTTLE CAM ADJUSTMENT CHOKE SOLENOID ADJUSTMENT aClose choke valves with manual choke leverbLoosen clamp screwsSee Figure 3-33 cHold plunger to bottom of solenoid and slide assembly aft to remove slack in linkage between plunger and choke leverdMove solenoid (only) aft .016 inch and tighten clamp screwsbAlign bottom mark on throttle cam with center of cam follower rollerLoosen carburetor cam follower screwMove arm to close throttle valves and retighten screwSee Figure 3-34aBottom mark on throttle cam should align with center of cam follower roller as roller makes contact with camSee Figure 3-34