1975 Johnson 4HP 4R75, 4W75 Outboards Service Manual, Page 55Get this manual
CUP AND STOP ASSEMBLY
" '_ BUSHING
RE-WIND SPRING
ROLL PIN
PULLEY ROPE
Figure 7-7Installing Rope in Pulley cInsert washer in cup and pulley assemblyHook end loop of starter spring to pulley roll pinSee Figure 7-5Position pulley and spring in cup and stop assembly with spring extending out through slot in cupSee Figure 7-8 dAssemble idler gear with shoulder against idler gear armInstall idler gear arm, and spring to pulley and cupBe sure to position stop on idler gear shaft between the two stops on the cup and stop assemblySee Figure 7-9Avoid turning pulley and disengaging end of springSLOT IN CUP
Figure 7-5Position of Spring in Pulley
CLEANING, INSPECTION, AND REPAIR