1975 Evinrude 40 HP Outboards Service Manual, PN 5093, Page 40Get this manual
bApply mixture of one part molybdenum sulfide to forty parts OMC Sea- Lube Anti-Corrosion Lube (measured by volume) around crankcase boss (armature plate pilot)See Figure 4-34Oil Delrin ring with OMC outboard lubricantInstall ring over edge of retainer platePosition support plate on crankcase Place retainer plate over support plate aligning holes with crankcaseAttach plateSee Figure 4-31Torque screws to specifications given in Section 2Carefully install armature plate over crankshaft to avoid damaging breaker armsUsing needle nose pliers in slots in Delrin ring, compress ring and locate armature plate over Delrin ringSee Figure 4-32Align holes in armature plate and support platefive screws and torque to specifications gi ven 'iffi Section 2Reconnect all leads, Packard and linkagesI, BREAKER POI NT AD,",USTME T
aFor breaker point adjustment, magneto must be assembled to motor and flywheel must be removedbDisconnect all leads from breaker pOint assembliesConnect meter or test light between breaker plate and forward breaker point screw terminalSee Figure 4-34cPlace gearshift in forward gearAdvancebreaker plate to full throttle position against stopPlace timing fixture OMC Special Tool (Part No386635) on crankshaftRotate the crankshaft so that the side of the fixture marked "T" (top) is aligned with the first projection on the armature plateSee Figure 4-34 "