1975 Evinrude 2HP Model 2502 Full Factory Service Manual, Page 22Get this manual
3- 6 bU leakage still exists, remove the ead shot with an appropriate sharp toolSee Figure 3-14
cClean and inspect casting openingIf the casting opening is normal, install new lead shot and flatten out with light hamme tapsCheck for leakageFUEL TANK Inspect the filler cap and gasket for wear, damage, or leakage; replace if necessar ybRemove shut- off valveRemove gum and varnish deposits by washing in OMC Accessory Engine CleanerApply drop of OMC part numbe 2007 63 Gasoila to threads at shut- off valve on installation to fuel tankcInspec the fuel tank for leakage leakage occurs, replace tankdFlush tank with clear gasoline or solvent at least once year
Figure 3-14Removing Lead Shot
CARBURETOR REASSEMBLY
GENERAL INSTRUCTIONS
Reassemble th carburetor, paying particular attention to the following procedureKeep all dust, dirt, and lint out of the carburetor during eassemblyBe sure that parts are lean and fr ee from gum and varnish when eassembling themReplace all gaskets and ealing washe sDO NOT attempt to us original gaskets and washers, as leaks may de velop after the engine is back in us e