1974 Johnson 135 HP Outboard Motors Service manual, Page 118Get this manual
9-6 The mating cable connector contains the terminals for engagement
with the receptac le terminals and held in the plastic housing by a
prong that catches in pocket of the housingThe terminals can be removed and eplaced simila rly to the receptacle terminalsThe connecto housing has water shed lip that covers the edge of the receptacle housing when fully engaged The assembled connector hould be positioned so that the lip is down to help prevent water from entering the housing and corroding the terminals
aECTRIC MOTOR DISASSEMBLY See Figure 9-3aUnplug cable at motor connectorbRemove trim and lilt Wlit from outboard and place in vise See Fi gure6Drain oil from reservoir Mark reservoir, motor hell and end cap for alignment on reassemblyc Loosen frame Screws until tapped holes in reservoir disengaged, do not remove screws ntirelydSlide motor shell, end cap and field assembly aU reservoir(Armature normally will stay in place, due to seal drag ePull armature out of reservoir Carefully slide motor hell away from end cap to expose wir ing con -