1974 Johnson 135 HP Outboard Motors Service manual, Page 108Get this manual
8-5 E NOTE
6It is possible to completely shear orr the wire, so be careful to advance the clamp screw to the point of contact only and then make just one complete turn to kink the wire without shearing it
first turning clamp screw (using 3 32" Allen wrench) until It just touches the wireNext advance this clamp screw one turn onlyTh is will kink the wire sufficiently to locate it in th casing guide Finallyinstall the anchor screw and tighten securelySee Figure 8-1 l
SAFETY WARNING
When assembling the remote controlecure anchoring of the control wires is extremely importantThe wires must be properly secured at both ends they may come loose during operation of the engineFollowing the procedur outlined above will insure safe installation7Snap nylon trunnion caps on cable runnion and position ru nnion in remote contr olSee Figure 8-1 0
is possible to completely shear off the Wire, so be careful to advance the clamp screw to the point of contact only and then make just one complet turn to kink the wire without shearing itIt