1973 Evinrude Norseman 40 HP Service Manual, Page 76Get this manual
Figure 8-9Starter Assembly Sequence Figure 8-7Removing Spring from Tool Base gApply light coat of OMC Sea-Lube AntiCorrosion Lubricant to nylon bushing and insert in pulleyAttach pawls and retainersLubricate spindle with OMC Type "A," and place wave washer and friction ring over washer and spindleCup side of ring must face flange on spindleAlign flat in ring with corresponding flat on spindleSee Figures 8-10 and 8-11hInsert this assembly into nylon bushing aligning slots in spindle with corresponding ribs in bushingRotate spindle to align pin with corresponding hole in starter housingSee Figure 8-10 and 8-11Be sure pawls are located between bushing and friction ringSecure with screw, washer, and nutiWith housing upside down on bench, wind pulley counterclockwise until spring is tightBack off about turn and align hole in pulley with hole in housingLock pulley by inserting punch thru holes in pulley and housingSee Figure 8-12
kApply OMC Sea-Lube Anti-Corrosion Lubricant to handle end of ropeUsing Starter Rope Threading Tool (Special Tool #378774), thread rope handleSee Figure 8-13Press rope into channel in rope anchor, with end of rope butting firmly against end of channelSee Figure 8-31Press rope anchor into handleallow rope to wind up on pulley