1972 Evinrude StarFlire 125 HP Outboards Service Manual, PN 4822, Page 75Get this manual
REMOVER TOOL
Figure 6-26
Figure 6-27Removing Driveshaft Lower Bearing with Set Screw
Figure 6-24Remove Pinion Locknut
With the locknut removed, remove pinion gear and pull the driveshaft out of the gearcaseShims, thrust washer, and bearing are removed with driveshaftiRemove forward gear, thrust washers, and bearingjUsing two 14-20 threaded ends of #380658 OMC Slide Hammer rods and two #311887 Hammers, remove oil pump from gearcaseSee Figure 6-25kIf necessary, remove lower driveshaft bearing using OMC Special Remover Tool #384096See Figures 6-26 and 6-27NOTE: Remove setscrew from starboard side of gearcaseSee Figure 6-27 insertIf gear case is staked, remove lower driveshaft bearing using OMC Special Remover-Installer Tool #385547 and Drive Handle #311880See Figure 6-26AAlign flat surfaces of remover tool fore and aft as illustrated