1972 Evinrude StarFlire 125 HP Outboards Service Manual, PN 4822, Page 73Get this manual
DRIVESHAFT
eRemove four screws, solenoid cover and wave washerLift cover, solenoids, shift rod and casing assembly from gearcaseSee Figures 6-18 and 6-19fRemove four bearing housing screwsUsing two inch 516-18 bolts (Special Tool #316982) and flywheel puller (Special Tool 378103), pull bearing housing from gearcaseSee Figure 6-20
gRemove two Truarc rings using No7 Truarc pliersSee Figure 6-21hWithdraw propeller shaft, retainer plate, reverse gear, thrust washers, thrust bearing and clutch dogSee Figure 6-22The reverse gear and bushing isassemblyDisassemble clutch dog from propeller shaft by removing pin retaining springSee Figure 6-23Remove the pinion locknut from the bottom of the driveshaft by using Driveshaft Holding Socket (Special Tool #312752), Figure 6-24Figure 6-16Water Pump