1971 Johnson 60HP outboards Service Manual, Page 70Get this manual
REASSEMBLY OF STERN AND SWIVEL BRACKETS aInstall pivot shaft bushing and new sealsbAssemble stern bracket to swivel bracketcAssemble pivot shaft and steering arm to swivel bl-acketArm faces forward and lower clamp bracket faces aftInstall nut and tighten until snug, then back off 12 turn and stake in places approximately 120 apartSee Figure 6-14
REASSEMBLY OF EXHAUST HOUSING AND ADAPTER
aIf removed, install water tubes and water pressure control valve, using new grommetsBe sure tubes are aligned properly with water pumpbApply Perfect Seal #4 to faces at exhaust housing and adapterUsing new gasket, install adapter assembly to exhaust housingDip screws in Perfect Seal #4 and tighten to torque specified in Section 2cInstall exhaust housing and adapter assembly to swivel bracket, and tighten all screws to torque specified in Section 2dAttach lower motor cover to adapter6 609 0
Figure 6-41Filling Gearcase
eInstall power head as described in Section 5
INSTALLATION OF GEARCASE
aPlace "0" ring on driveshaftexhaust housing surfacesApply Sealer 1000 to gear case and