1971 Johnson 60HP outboards Service Manual, Page 67Get this manual
dInstall oil pump valve housing and tighten screws to torque specified in Section 2eInstall screen on valve housingfNote: Forward end of pump has locating pinPump must locate in pin hole in gear case to be seated properlyInstall pump in gearcase, locate on pin, and seat pump as far forward as it will goUnless properly seated, solenoid rod and casing will not align with pump valves
gInstall Truarc retaining ring FLAT SIDE TOWARD PUMP uSing Truarc Pliers (E Models only)hInstall lower driveshaft bearing using bearing installer (See Fig6-31)See insert Figure 6-31Place bearing on driver lettered side of case toward driverPlace bearing and driver in position in gearcaseInsert tool with large washer, bearing, washer, and nut through top of gearcaseThread rod into driverUsing wrenCh, tighten nut to draw bearing into gearcaseiInstall thrust washer, bearing and forward gear as an assemblySee Figure 6-17jInstall drive shaft, thrust washer, bearing, and pinion gear using driveshaft holding socket (Special Tool #312752)Torque nut to 40-45 foot-pounds