1971 Johnson 60HP outboards Service Manual, Page 62Get this manual
6-6 dRemove four screws and lift adapter, inner exhaust tube, and water tube assembly from exhaust housingSee Figure 6-13eIf necessary to remove water tubes, remove screws attaching water tube flanges to adapterSee Figure 6-13 insertInner eXhaust tube and gasket can be removed from adapter if necessary by removing five screws DISASSEMBlY OF STERN
SWIVEL BRACKETS
aRemove staked 1- 1 2" nut from bottom of pivot and steering shaft assemblySee Figure 6-14Withdraw shaft from lower bracketShaft is splined to bracketSee Figure 6-15NOTE: On reassembly coat splines with Loctite grade key fitTighten pivot shaft nut until snugThen back off 1 turnstake in places approximately 120 apartSee Figures 6-14 and 6-15bUpper and lower seals in sWivel bracket may be bronze bushing slides outoutUpper
cRemove the thrust rod and retainer, and the thrust rod spring from the stern bracketRemove screws attaching tilt levers to stern bracketdRemove two .screws fastening port and starboard stern bracketsRemove tilting shaft bolt, nut, and washers from top of stern bracketsSee Figure 6-,1 2