1971 Johnson 60HP outboards Service Manual, Page 40Get this manual
4-9 and standard motor ignition coilConnect the coil to the ignition analyzer as for the coil testConnect separate test lead with suitable clips to the secondary terminal of the coil (by-pass the MA-12 resistor adapter when using the stevens Model MA-75 ignition analyzer) and to the conductor of the component being tested (lead terminals on distributor cap, rotor arm, spark plug high tension lead)Probe the entire insulated surface of the component being tested with the grounded test probeSee Figures 4-17 and 4-18 Arcing will be apparent wherever the insulation has broken down, due to moisture or carbon trailsDISTRIBUTION CHAMBER
It is very important that the stator retaining screws be tight
This will assure positive location and prevent dirt from entering the distribution chamberThe ventilating screens in the distributor cap should be kept clean to assure proper ventilationApply OMC Type grease to high tension distributor or leads before installing in distributor capSee Figure 4-2Fill distributor towers 1 full of OMC type "c" grease