1971 Johnson 4HP Outboard Motors Service Manual, Page 32Get this manual
REASSEMBLY OF MOTOR MAGNETO If f1ywheel key has been removed, reassemble to crankshaft with outer edge verticalSee Figure 4-16
Figure 4-15
Locating Ring
Alignment of the magneto will simplified with the of locating ring (5 8" thick 4.472" machined to fit over the four See Figure 4-15Figure 4-17Armature Plate Reconnect leads the armature plate, making sure that connections are clean and tightdMake sure that under the forward new oiler wick is installed See Figure 4-6Insta11 is making certain that side marked See Figure 4-17
Apply coat of lubricant to the armature plate support ring and retaining ringInstali retaining ring with tapered side down, and port ringA1ign retaining ring to correspond to the position of the armature plateSee Figure -17DO NOT add or grease to the oiler wick the magneto