1971 Evinrude StarFlite 100 HP Outboards Service Manual, PN 4753, Page 94Get this manual
7-15 STEP4
aMomentarily short the purple clipper lead to housing of clipper circuitbRelease purple lead aI),d connect Ohmmeter as shown in Figure CcIf meter reads greater than 300 ohms, proceed to step 5dIf meter reads less than 300 ohms or if pointer moves toward zero ohms and returns to infinite ohms, replace clipperSTEP5
CASE LEAD
aMomentarily short the purple cuit
lead to housing of clipper cir"
bRelease purple lead and connect Ohmmeter as shown in Figure DcIf meter pointer moves toward zero ohms and returns to infinity, clipper is goodRefer to your service manual or C.DTroubleshooting Booklet and check for failure of the charging circuit, C.Dignition circuit, starter circuit, or shift circuitdIf meter pointer does not move, or goes to zero ohms and stays there, replace clipper