1971 Evinrude StarFlite 100 HP Outboards Service Manual, PN 4753, Page 73Get this manual
Figure 6-25Removing Oil Pump With the locknut removed, remove pIllIOn gear and pull the driveshaft out of the gearcaseShims, thrust washer, and bearing are removed with driveshaftiRemove forward gear, thrust washers, and bearing
jUsing two 14-20 threaded ends of #380658 OMC Slide Hammer rods and two #311887 Hammers, remove oil pump from gearcaseSee Figure 6-25
Figure 6-24Remove Pinion Locknut
REMOVER TOOL384096
kIf necessary, remove lower driveshaft bearing using OMC Special Remover Tool #384096See Figures 6-26 and 6-27
PROPELLER SHAFT BEARING HOUSING Oil seals can be removed by driving them outmoved in the same manner, if necessaryOIL PUMP Figure 6-26