1971 Evinrude StarFlite 100 HP Outboards Service Manual, PN 4753, Page 41Get this manual
Figure 4-14Leakage Test on Distributor Cap, Rotor, and High Tension Leads aInstall reverse cut-off spring over top of crankshaft, flat side down, using small amount of OMC TYPE grease on surface of spring that rides on crankshaftSee Figure 4-15Oil and assemble the retainer to the distributor base and attach assembly to crankcase with four retainer clamps and screwsSee Figure 4-16Install breaker point setsSee Figure 4-16Adjust breaker pointsSee Specifications, Section and Figure 4-17bInstall the rotor, wave washer (see Figure 4-1), and distributor cap making sure cap is properly seatedInstall stator with screws dipped in Loctite Screw Lock and torque to 48 to 60 inch lbsIf flywheel key has been removed, reassemble to crankshaft with outer