1971 Evinrude StarFlite 100 HP Outboards Service Manual, PN 4753, Page 39Get this manual
cPoints are set with ohmmeterSet rocker arm on high lobe of camClose points with allen wrench until meter reads zeroBack off point notchesUse same procedure on both sets of points3After points are reset, check engine timing
DO'S AND DON'TS FOR C.DIGNITION SYSTEMS
DO make sure of clean, tight connections on all wiring, especially all ground connectionsDO make sure correct battery polarity is observed (negative ground) and that battery cable connections are clean and tight(Owner should be cautioned to check this periodically as preventive maintenance DO make sure the plug-in connections are fully engaged and the terminals are free of corrosionDO make sure all wiring is located properly so that it will not rub against any metal edgesVibration would eventually wear hole in the insulation and result in service problem that might be difficult to locateDO make sure accurate test equipment is used when troubleshooting the systemDO use proper tools when installing system components