1971 Evinrude Fisherman 6HP outboards Service Manual, Page 55Get this manual
gInstall new seals in head bearing and bearing housingInstall new grommet in impeller housing water tube outlethPosition new gasket and bearing housing on gearcaseApply Sealer 1000 to bearing housing and position impeller plate over bearing housingPlace pump housing and impeller on driveshaftiPlace driveshaft with impeller and housing in position on gearcaseRotate driveshaft to engage pinion gearInstall impeller pin, oil impeller, and position impeller over pinInstall impeller housing over impeller, turning driveshaft in clockwise direction to pOSition impeller blades for clockwise rotationSee Figure 6-3Attach impeller housing to gearcase with screws dipped in Perfect Seal #4 and tighten to speCified torqueInstall roll pinGEARCASE PRESSURE TEST To test gearcase sealing, proceed as follows: 1Remove drain plug and screw in pressure test gaugeSee Figure 6-23stevens Experimental pressure test gauge illustrated2Pump pressure up to 16-18 poundsGearcase must hold 16-18 pounds pressure REASSEMBLY OF STERN, SWIVEL, AND STEERING BRACKETS TO EXHAUST HOUSING