1971 Evinrude Fisherman 6HP outboards Service Manual, Page 52Get this manual
DISASSEMBLY OF STERN BRACKET AND SWIVEL BRACKET aRemove nut, washer, and spring from tilt bolt and withdraw bolt to separate stern brackets from swivel bracketTilting lever can be removed by removing two screws holding port and starboard stern brackets togetherRemove the upper liner pin by pushing inwardSee Figure 6-16bThe pilot shaft upper thrust washer and the upper liner may be lifted out of the swivel bracketThe steering tension spacer and plate also lift outRemove lower bushing, "0" dng and thrust washerST EERING FRICTION EV RSE LINER STEERING ')_: FRICTI0N LINER PLATE ARM
iSPRINGU
Figure 6-14Shift Rod Bushing Punch bLoosen steering friCtion -screw, and lift steering bracket and pilot shaft from swivel bracketSee Figure 6-15Pilot shaft can be separated from steering bracket by removing four screws
SWIVEL !I BRACKET.jTHRUST T"'-WASHER UPP R
,FRICTION SCREW
SPRING LOWER
cTo remove throttle control gear, loosen screw holding pinion gear to short throttle shaft and gear assemblyWithdraw shaft and lift throttle control gear from bushingBushing can be removed if servicing is requiredSee Figure 6-15