1971 Evinrude Fisherman 6HP outboards Service Manual, Page 50Get this manual
ing the pilot shaft between the port and starboard lower mount housingsSee Figure 6-7dRemove the forward nut on the upper front rubber mountSee Figure 6-8eThe exhaust housing can now be lifted from the steering bracket and pilot shaftfUsing length of throttle wire with small hook on it, hook the water tube grommet inside of the exhaust housing and pull it outLOWER SCREW ALL THE WAY 680774
gIf necessary, remove shift handle by removing the screw and washer from the shift rod lever and bushing and pulling out the handle and shaft assemblySee Figure 6- 4
Figure 6-6Shift Rod Connector dRotate propeller to align pin in driveshaft with slot in exhaust housingSee insert, Figure 6-8eDrop gearcase sufficiently to expose shift rod connectorRemove lower connector screwSee Figure 6-6fRemove upper and lower gear case assembly from exhaust housing or gear case extension
REMOVAL OF EXHAUST HOUSING
aRemove the power head as described in Section 5Remove lower motor cover from exhaust housing by removing four screws and washersbRemove the gearcase as described in "Removal of Gearcase cRemove four nuts from upper and lower rubber side mounts, and remove two screws clampFigure 6-8Removing Front Mount