1971 Evinrude 40HP outboards Service Manual, Page 35Get this manual
REASSEMBLY OF MAGNETO Reassemble components which were removed from the magneto armature plate, following the reverse order of disassembly and paying particular attention to the followingaCorrect locating of the coil and lamination assemblies is governed by machined mounting surfaces on the armature plateCoil lamination heels should be flush with machined surfacesSee Figure 4-14Alignment of the magneto coils will be Simplified with the use of coil locating ring (58" thick 4.472" ill) machined to fit over the four bossesSee Figure 4-15
bReconnect all leads on the magneto, making sure that connections are clean and tightcMake sure that new oiler wick is installed under the forward coilSee Figure 4-16