1970 Johnson 115 HP Outboard Motor Service manual, Page 73Get this manual
e, Remove four screwssolenoid cover and wave washer
solenoidsshift rod and casing assembly from gearcaseSee Figures 6- 18 and 6-19fRemove four bearing housing screws using long 1 4" Alle wrenchUsing slide hamme with hooked end, OMC Special Tool 1383171, pull bearing housing from gear caseSee Figure 6- 20
gRemove two Truarc rings using No.7 Truarc pliersSee Figure 6- 21hWithdraw propeller Shaft, retainer platereverse gear, thrust washers, thrust bearing and clutch dogSee Figure22The reverse gear and bushing is an assemblyDisassemble clutch dog from prope ller shalt by removing pin etaining springSee Figure 6- 23 Remove the pinion locknut from the bottom of the driveshaft by using Driveshalt Holding Socket (Special ool 3 12752), Figure 6-24Figure 6-16Water Pump