1970 Johnson 115 HP Outboard Motor Service manual, Page 31Get this manual
To assemble hose clamps, rip clamp firm ly with pliersApply light pressur to hook on top ide with screwdrive rSqueeze clamp with pliers until hooks interlockSee Figure 3-27CONNECTOR HOUSINGS NOTE
U "0ri ng is damaged air will enter fuel line and carburetorMotor will run out of fuel,Figure 3-26
Ins tallation of the "0" ring the fu el hose connector requires the use of two ins truments, one to hold the plunger down and one to remove the "0" ringBoth instruments are illus trated and can be made easily of 16 gage (116" diameter) steel wireA piece of discarded remote control wire may be usedForm small hook on the bottom end of the lo nger tool of about 1 16" radiusAlter cutting the wires to length, be ure the ends are rounded off to revent scratching damaging the" ring seats or the plungersSee Figure 3-28To remove the "0ring from the connector, proceed as follows: aPlace the cOIlllector in vise between two wood blocksbPush the plunger down with the straight instrumentcInsert the hooked instrument between the "0" ri ng and its seat with the hook in flat or horizontal positionSee Figure 3-29dTwis the hook ound to grasp the" ring, the pull outTo install the "0" ring in the connector, proceed as follows: