1970 Johnson 1.5 HP Outboard Motor Service Manual, Page 30Get this manual
4-7 dInstall liner crankcaseBoss will fit groove in crankcase on1y when curved side of liner tab faces crankcaseFigure -7 the armature p1ate in position over the bushing with liner tab in s10t in armature p1ate hubMake sure that throttle fol1ower is not caught under throttle contr01 Insert screw and tighten just enough to ho1d armature plate in se1ected position yet al10w it to turned without excessive effortConnect ground wirefCheck crankshaft and flywhee1 tapers for traces of oilThis assembly must perfectly dryswab tapered surfaces with s01vent and blow dry with compressed airInspect both tapers for burrs nicksPARALLEL
FLYWHEEL
DO NOT permit s01vent used to oiler wick
tapers to wash oil out of
Figure 4-17F1ywhee1 Position
gReplace flywhee1Check for spark connecting the spark p1ug high tension 1ead to spark checker (8tevens Experimental Part #8- 21 8-13), and cranking the engine with Tighten flywhee1 nut to torque specified in 8ection 2hConnect the high tension 1ead wire to the spark p1ug, and insert grommet in slot in cylinder headMake sure that the termina1 in the spark p1ug 1ead cover makes firm contact with the spark plug terminalFigure 4-2