1970 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Service Manual 4687, Page 75Get this manual
iInstall spindle washer and screw SPRING LOOPHOUSING END
jApply OMC Type "A" lubricant to handle end of rope Using Starter Rope Threading Tool (Special Tool #378774), thread rope handle See Figure 8-10Press rope into channel in rope anchor, with end of rope butting firmly against end of channelkPress rope anchor into handleRemove knot and allow rope to wind up on pulley1Pull the starter rope to make sure pawls work properlyWhen the starter rope is pulled, the pawls should pivot out to engage the flywheel ratchetOn releaSing the rope, the pawls should retract to their starting positions
Figure 8-7Removing Pulley from Base on the pulley so that the stud moves into the spring loop, forcing the pin outSee Figure 8-8fTie knot in one end of the ropeIf installing new rope, be sure length measures 73-34 inchesUsing match or cigarette lighter, fuse nylon strands at each end for about 12 inchRope ends must be stiff to hold properly in anchor and pulley
FRICTION RING
WASHER BUSHING