1970 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Service Manual 4687, Page 33Get this manual
REASSEMBLY OF MAGNETO Reassemble components which were removed from the magneto armature plate, following the reverse order of disassembly and paying particular attention to the following: aCorrect locating of the coil and lamination assemblies is governed by machined mounting surfaces on the armature plateCoil lamination heels should be flush with machined surfacesSee Figure 4-14Alignment of the magneto coils will be Simplified with the use of coil locating ring (58" thick 4.472" ID) machined to fit over the four bosses See Figure 4-15
b.Reconnect all leads on the magneto, making sur that connections are clean and tightc Make sure that new oiler wick is installed under the forward coilSee Figure 4-16