1970 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Service Manual 4687, Page 24Get this manual
Figure 3-26Removing Hose Clamp
Figure 3-29Removing "0" Rings "0" ringBoth instruments are illustrated and can be made easily of 16 gage (1 16" diameter) steel wireA piece of discarded remote control wire may be usedForm small hook on the bottom end of the longer tool of about 1 16" radiusAfter cutting the wires to lengthbe sure the ends are rounded off to prevent scratching or damaging the "0" ring seats or the plungersSee Figure 3-28NOTE
If "0" ring is damaged air will enter fuel line and carburetorMotor will run out of fuel
Figure 3-27Attaching Hose Clamp HOSE AND PRIMER BULB ASSEMBLY CLAMPS To disassemble hose clamps, grip clamp with pliersBend overlapping hook backward (in direction of arrow) to release clampSee Figure 3-26To assemble hose clampsgrip clamp firmly with pliersApply slight pressure to hook on top side with screwdriverSqueeze clamp with pliers until hooks interlockSee Figure 3-27CONNECTOR HOUSINGS Installation of the "0" ring in the fuel hose connectors requires the use of two instruments, one to hold the plunger down and one to remove the