1968 Evinrude Starflite 100 HP outboards Service Manual, Page 70Get this manual
sRemove the forward coil and lead assembly using Front Coil Remover Assembly (Special Tool #380658), Figure 6-21After the coil is free, make sure that the coil lead is free and the knife disconnect does not get stuck in the passage leading to the gear cavity vPlace the adapter from the Bearing and Seal Remover (Special Tool #380659) on the roller bearingAttach the Roller Bearing Remover (Special Tool #311885) to the Handle (Special Tool #311880) and drive the roller bearing out as shown in Figure 6-23
ADAPTER
Figure 6-21Removing ForwarG Coil
tRemove front propeller shaft bearingNext attach the Bearing Cup Remover (Special Tool #380657) to the bealting cupAttach slide hammer and bolt from the Coil Remover tool to the center screw of the Bearing Cup Remover and pull the bearing cup
Figure 6-23Driving Out Roller Bearing Disassembly of Sub-Assemblies 1Gear, Clutch Spring, Hub and Bearing Assemblies