1968 Evinrude Starflite 100 HP outboards Service Manual, Page 69Get this manual
nAfter the coil Wire is out of its passage, insert two gear case head screws into opposite sides of the coil and carefully rock it out, Figure 6-19oRemove propeller shaft reverse gear, clutch hub cover and brass washer and clutch spring assembly NOTE
Make sure that the cam lobe on the shaft clears the oil pump plunger
Figure 6-17Removing Thrust Plate, Washer, and Bearing remove the gear case head, use both slide hammers from Front Coil Remover Assembly (Special Tool #380658) and two long bolts of suitable length with 14-20 thread on one endThe two bolts will have to be obtained locallyAssemble the slide hammers and bolts and screw them into two of the tapped holes on opposite side of the gearcase head and pull it from the gearcase1Remove the thrust bearing and thrust washers from the propeller shaftRemove the tru-arc retaining ring using Coil Retaining Ring Pliers (Special Tool #311879)See Figure 6-18