1968 Evinrude Starflite 100 HP outboards Service Manual, Page 48Get this manual
Figure 5-15Bearing Retainer Plate Screws
Figure 5-13Disassembling Needle Bearings
To remove bearing, press out from top side of crankcase head with arbor press
dRemove four screws (lower crankcase head to lower bearing retainer plate) and remove lower crankcase head from crankshaftSee Figure 5-15Use Truarc pliers No4 (Special Tool #307429) to remove retaining ring under bearingFigure 5-16Pulling Lower Crankshaft Bearing eInspect ball bearing at lower end of crankshaft and remove if damagedThis can be accomplished by using flywheel puller (Special Tool #378103) provided with four screws 14-28 4" long, and threading the screws into the tapped holes in the bearing retainer plate(Screws are provided as part of adapter kit, Special Tool #378104 See Figure 5-16