1968 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Outboards Service Manual, Page 69Get this manual
dJar the housing, bottom side down, to dis10dge spring and pulley the bench
CLEANING, INSPECTION, AND REPAIR
Wash meta1 components in solvel1t such as 801vaso1 and dry with compressed airInspect spring for broken end loops and weak tensionExamine pawls for weardInspect friction ring and spril1gspindle bushing, spindle, and retainersInspect rope and discard if frayedsure to replace with starter rope cut to 1ength of 73- 3 inchesfExamine and housing for sharp edges and rough surfaces that could fray rope File and polish to remove
Figure 8- 5Winding Spring P1ace the pulley in position the base plate, making sure that the cel1ter pin fits into the center loop of the springInsert bushing and handle into pulley and base p1ateUse fixture crank to wind spring in counterclockwise directionFigure 8-5 When the spring is wound tight, re1ease at least turn, cOl1til1uil1g to release until 100p il1 spring lines up with the hole drilled through edge of pulley8lide the dowel pin through hole in pulley and spring loop See Figure 8-6dCarefully remove the hand crank and bushingLift pulley off base plate, holding spring in pulleyFigure 8-7Lubricate spring with lubricantP1ace pulley and spring into starter housing, making certain that the outside spring loop is top of its appropriate stud in the housingPress down