1968 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Outboards Service Manual, Page 57Get this manual
STEERING BRACKET
THRUST WASHER UPPER LINER PIN SPACER' SPRING -
STEERING ADJUSTMENT SCREW AND
SPRING ONICAL WASHER ARM BUMPER LINKS
Figure 6-18Trimming Gearcase Seal gAttach skeg to gearcase with screws dipped in Perfect Seal #4Tighten end screws firstInstall pivot screw and gasketCheck to make sure seal is not pinched between gearcase and skegTighten the remaining screws, starting at the center and alternating from side to side progressively toward the endsto torque specified in Section 2Check gearcase for freenesshApply fine bead of Sealer 1000 to gear housing, and place impeller plate in position gearcaseInstall driveshaft in gearcaseOil impeller and slide down driveshaft aligning with impeller pinInstall impel1er housing, twisting driveshaft clockwise as viewed from top to seal impeller vanes in proper direction of rotationAttach impeller housing to gearcase with screws dipped in Perfect Seal #4 and tighten to torque specified in Section 2Place new ring end of driveshaft" ''''";'1 -