1968 Evinrude Ski-Twin, Ski-Twin Electric 33 HP Outboards Service Manual, Page 25Get this manual
R ING PLUNGER
Figure 3-26Removing Hose Clamp
Figure 3-29Removing
ringBoth instruments illustrated and made easily of 16 gage (1 16" steel wire piece of discarded remote control wire usedForm small hook the bottom end of the longer tool of about 1 16" radius After cutting the wires to length, sure the ends rounded off to prevent scratching damaging the ring seats the plungersSee Figure 3-28NOTE ring is line and carburetorfuelIf
air wil1 enter fuel Motor wil1 out of
Figure 3-27Attaching Hose Clamp HOSE AND BULB ASSEMBLY
the ceed as follows:
ring from the connector, vise between two wood
Place the connector in blocks
Push the plunger down with the straight instrumentdisassemble hose clamps, grip clamp with pliersBend overlapping hook backward (in direction of arrow) to release clampSee Figure 3-26assemble hose clampsgrip clamp firmly with pliersApply slight pressure to hook top side with screwdriverSqueeze clamp with pliers until hooks interlock See Figure 3-27CONNECTOR HOUSINGS Installation of the ring in the fuel hose nectors requires the use of two instrumentsto hold the plunger down and to the