1968 Evinrude Big Twin, Big Twin Electric, Lark 40 HP Outboards Service Manual, Page 30Get this manual
Figure 3-29
Ring Tools
Figure 3-28Attaching Hose Clamp easily of 16 gage (l16" diameter) steel wirepiece of discarded remote control wire usedForm small hook the bottom end of the longer tool of about 116" radiusAfter cutting the wires to length, sure the ends are rounded off to prevent scratching or damaging the ring seats or the plungersSee Figure 3-29remove the as follows: ring from the connector, proceed vise between two wood
PLUNGER
Place the connector in blocks
Push the plunger down with the straight instrumentIns ert the hooked instrument between the ring and its seat with the hook in flat or hori.z ontal positionSee Figure 3-30dTwist the hook around to grasp the outinstall tl1e follows: Place ring, then Figure 3-30Removing Rings