1967 Evinrude StarFlite 80 HP Outboards Service Manual, PN 4359, Page 60Get this manual
haust housing cover from outer exhaust housing assemblycThe exhaust housing and adapter plate, which carry the power head and thermostat, are rubber mounted to the front exhaust cover To release the exhaust housing, disconnect the shift linkage, and remove the two bottom screws from the upper side rubber mounts, and the four lower front mount screwsSee Figure 6-10dTo remove adapter plate, remove five screws attaching adapter plate to outer exhaust housingRemove two upper rubber mounts to adapter screws Figure 6-8Electric Shift Wire Connections wires so the terminals can be disconnectedTerminals are located adjacent to the exhaust coverSeparate terminalsSee Figure 6-8Pull the shift cable down and through the outer cover plate opening Apply liquid soap or oil to the cable and remove the inner cover and clampdRemove eight screws holding gearcase to exhaust housing or gearcase extension, if usedSee Figure 6-9Pull gearcase straight away from exhaust housing to disengage driveshaft from crankshaft and water tubes from grommetsAvoid damaging electric shift cable, if used