1967 Evinrude StarFlite 80 HP Outboards Service Manual, PN 4359, Page 48Get this manual
cLift the upper crankcase head from the crankshaftTo remove seal, insert punch through bottom of bearing to engage seal lip, and drive eal out with hammerSee Figure 5-15DO NOT reuse sealTo remo"ve bearingpress out from top side of crankcase head with arbor pressBEARING
stall complete set of new rings on eve power head service jobhRemove wrist pin retaining ring, using Truarc No1 pliers (Special Tool #303857)See Figure 5-19R TAIN IN G
SCREWS 1
B ARING EA D
Figure 5-16Bearing Retainer Plate Screws dRemove four screws (lower crankshaft head to lower bearing retainer plate) and remove lower crankcase head from crankshaftSee Figure 5-16Use Truarc pliers No4 (Special Tool #307429) to remove retaining ring under bearing eInspect ball bearing at lower end of crankshaft and remove if damagedThis can be ccomplished by using flywheel puller (Special Tool #378103) provided with four screws 14-28 4" long, and threa ding the screws into the tapped holes in the bearing Figure 5-18Removing Center Journal Bearing